F7413 DATASHEET PDF

F Datasheet, F PDF, F Data sheet, F manual, F pdf, F, datenblatt, Electronics F, alldatasheet, free, datasheet. IRF Datasheet IRF Component IRF Integrated Circuit IRF Schematic IRF Application Note IRF IRF74 IRF7 IRF IR I RF F . datasheet pdf data sheet FREE from Datasheet (data sheet) QTRPBF 13QTRPBF 3QTRPBF QTRPBF TRPBF RPBF PBF BF F

Author: Keshakar Zunris
Country: Djibouti
Language: English (Spanish)
Genre: Technology
Published (Last): 23 December 2006
Pages: 215
PDF File Size: 10.39 Mb
ePub File Size: 6.37 Mb
ISBN: 923-2-33227-150-3
Downloads: 64677
Price: Free* [*Free Regsitration Required]
Uploader: Ketaxe

Well, nothing else to do but give her a try then. Give me a resistance reading for pin 4 and lets see if we can change the F74413 by modding this RT IC.

Those are the outputs. Odd pcb layout vmods.

If you dont get an increase after turns, then Datzsheet would stop and we need to take another look at it. Pin 13 is the inverting input for output pin Once we figure out which output is supplying the Vddr and Vgpu, we can try modding the inverting inpout pin each output pin.

If the resistance between 13 and GND is ohms, then a 1K VR is gonna lower resistance by a solid 60 ohms, datasheeet may be to much to start with since we are shooting in the dark right now.

  AVATAR THEOPHILE GAUTIER PDF

The back of the card is almost blank except for one mosfet which reads “APME” There are also small 3 legged ic things that read “PH0o BCP68” On the front of the card there are more things that look like regs. I feel for ya tho: The LM chip is prob controlling either Vgpu or Vddr.

IRF7413 Datasheet PDF

If possible, please check the voltage on 14 and post that. There is nothing else really. My pop has the camera so I can’t take any at least not tonight. Anyone make sense of that one?

I’m almost sure that the 2. Well I looked over the datasheet and which pin do you think is likely to be it? Sounds like the vdd voltage right there. Keep a good eye on the voltage as you adjust the VR.

Data Sheet Catalog: Begin marking SMD with F

I would start with a 5kk VR just to be safe. Oddly enough I found a connection between the ricktek chip and the cap measuring 2.

That sounds a bit low for Vddr, thats probably vddq. I wanna try and find some volt mods for it.

We need to make sure its Vddr and not Vddq. Ok, pin 5 is the actual output for the RT ICs. I found connectivity between pins 13 and a cap on the back of the card that reads 2. Then do the connectivity test between those points and pins 1, 7, 8, and If Output Pin 1 is supplying Vddr, then we try modding to pin 2.

  GUV 8700 PDF

F Datasheet, PDF – Alldatasheet

Those are all the ICs on the board. The card is a pro I just got back from rma and it doesn’t look anything like the one I had, layout wise at least. Do a resistance between 13 and GND and post what you find. Resistance between pin datssheet and a ground is Got some pics now. I’ll try and see if I can get some pics, but those are all the ic’s on the card so can anything be worked from that? Just odd the 13 is tied directly to that cap. BTW HF, this is a not a ti I dont recall what the baseline Vddr is for the cards.