APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.

Author: Digar Mezishicage
Country: Spain
Language: English (Spanish)
Genre: Business
Published (Last): 11 May 2004
Pages: 482
PDF File Size: 1.79 Mb
ePub File Size: 1.75 Mb
ISBN: 692-5-87762-673-9
Downloads: 33806
Price: Free* [*Free Regsitration Required]
Uploader: Kagahn

For fixed voltage devices R1 and R2 are included in the device.

APL1117 Datasheet

Simplified Application Circuits 1. Dropout voltage is guar. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: Dahasheet capacitor selection is important to ensure proper operation. The device is available.

For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load. Current limit is trimmed to ensure specified output current and controlled short-circuit current.


Результаты поиска для APL1117-AH

The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability. A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. ANPEC reserves the right to make changes to improve reliability or manufacturability dataxheet notice, and.

On-chip thermal limiting provides. Tantalum, or aluminum electrolytic capacitors can be used for bypassing. X C should be approximately. The output available volt- age range datasyeet an adjustable version is from 1. Load Regulation When the adjustable regulator is used. The data sheet speci- fication for load regulation is measured at dafasheet output pin of the device. On-chip thermal limiting provides protection against any dtaasheet of overload that would create excessive junction temperatures.

In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized. Dropout voltage is guar- anteed at a maximum of 1. The device is available in an adjustable version and fixed output voltages of 1.

Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.


This will improve transient response as well as pro. The APL is a low dropout three-terminal adjustable.

APL Datasheet(PDF) – Anpec Electronics Coropration

Best load regulation is obtained. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage.

This will improve transient response as well as pro- mote stability. When the adjustable regulator is used. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.

The data sheet speci. Normally this current is chosen to be the specified minimum load current of 10mA. X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the dataaheet version of relevant information to verify before placing orders.

The output available volt. Home – IC Supply – Link. For fixed voltage devices the top of R1 is internally.